
The set is designed for installation in wheeled vehicles with an external antenna on the vehicle body. The set can be powered from the 12 V or 24 V vehicle electrical system. The RF23 transceiver design allows you to connect an external GPS antenna mounted on the vehicle body.
PN (RN): 7018.000.42
VEHICLE ANTENNA SET REQUIREMENTS | |
---|---|
Frequency range | 25 MHz to 146 MHz, recommended 30 MHz to 108 MHz |
Nominal impedance | 50 Ω |
VSWR | max. 3.5 |
Power load | min. 10 W |
ANTENNA CABLE REQUIREMENTS | |
Material | RG_58_C/U-01 |
Cable length | max. 10 m |
RF23 connector | TNC according to MIL-STD–348A |
Antenna connector | depending on the antenna connector type |
GPS ANTENNA CABLE REQUIREMENTS | |
Material | RG58, LMR-195-FR-W |
Cable length | max. 15 m |
RF23 connector | SMA according to MIL-STD–348A |
Antenna connector | depending on the antenna connector type |
EXTERNAL GPS ANTENNA REQUIREMENTS | |
Passive or active | |
Supply voltage for the preamplifier | 3.3V |
RF23 operating instructions | 2300.010.42 |
---|---|
RF23 short operating instructions | 2300.011.42 |
MA1302 operating instructions | 7018.010.22 |

RF23 - EPM handheld transceiver
An EPM handheld multiband transceiver with enhanced resistance to radio-electronic warfare designed for tactical command level for all military branches.
- integrated GPS receiver
- audio accessories with U-229/U connector

MA1302 - Vehicle support
MA1302 vehicle support supplies #RF20# transceivers with power and charges battery packs for this transceiver in vehicles with 12 V…

LP1302 - Battery pack
Power supply for RF20 radio system transceivers. The battery pack consists of serial-parallel set of four LiIon cells with protective diagnostic circuits, and a capacity display.
- nominal capacity 3.6 Ah