The Telescopic winch driven mast 10 m is designed for field use or for installation in vehicles. It serves as antenna carrier for transceiver sets in field.
Mast sections are produced from composition materials.
The mast is equipped with a special winch for easy pulling the mast out and in with the antenna installed.
The position of the winch is adjustable: the first winch position is used for pulling the mast out in free field; the second position is used for pulling out the mast mounted on a vehicle.
Antenna mast is intended for use in field conditions to install all types of GROUNDPLANE antennas supplied by DICOM.
Individual sections are made of composite materials characterized by high rigidity/weight ratio and high resistance to environmental conditions.
The mast is anchored on two levels with three anchor guys at each level. If necessary, the mast can be attached directly to the vehicle by mounting adapters.
Short-distance communication between RF20 or RF1301 transceivers.
This antenna can also be used with the RF13 transceiver.
The AS1301 – Short tape antenna 0.5 m proper consists of a flexible steel tape, covered by a plastic sleeve.
The steel tape makes it possible to bend the antenna at any point, the minimum bending radius is 1 cm.
The antenna is electrically connected to the transceiver via a BNC connector, mechanical resistance is secured by a screw joint on the transceiver and a cap nut on the antenna.
This proved method ensures a high mechanical resistance during motion on terrain and in case of a possible falling of the transceiver.
The design of the antenna makes it possible to fold it to the length of 0.25 m.