T-1000 1kW MF/HF TRANSMITTER

Sunair provides the robust solution for mission-critical communications applications requiring reliable coverage.

The transmitter system combines a solid-state radio (exciter or transceiver), RF power amplification, and control technology to produce
a fail-safe high-power solution that operates in the 1.5 MHz to 30 MHz frequency range.

1-kW System

The Sunair 1-kW System is supplied as an integrated system consisting of the Sunair RT-9000E Software-Defined Next
Generation HF SSB/ISB Transceiver or T-9000E Software-Defined Next Generation HF SSB/ISB Transmitter, the F-9810
Post-selector, and the LPA-9600 1-kW Power Amplifier. Maximum power output is 1 kW at 100% duty cycle to facilitate
long-range communications when coupled with the appropriate antenna system. Output power is reducible to 500 W.
Standard input voltage is 115 / 230 Vac ±15 %; 50 / 60 Hz; single phase, with a modest power requirement of ≤ 4.6 kVA.

The amplifier architecture consists of four RF/PS modules producing over 300 W each, allowing the LPA-9600 to deliver
conservative averages of 1000 or 500 W. The radio, whether a T-9000E or RT-9000E, actively monitors system balance
and performance, providing power control and safety shutdown in the event of internal module failure, system failures, or
external failures such high antenna VSWR (as well as antenna short or open circuit)
Advanced built-in-test (BITE) capability reports the status of the Sunair 1-kW System down to the Lowest Replaceable
Unit (LRU) level providing English messages on the display of the radio, whether T-9000E or RT-9000E, and then to a
remote site when configured. Individual LRU fault indication and the system’s intuitive modular design allows for ease
of maintenance and upgrade throughout the equipment life cycle at minimal expense. These high-performing niche
products are in daily service as integral components of critical strategic communications solutions for leading defense,
peacekeeping, and aviation agencies around the world.

Rack Mounting

Either Sunair system can be rack mounted into your existing racks using offered rackmount kits. Another option is for
Sunair to provide a portable rack that is completely wired and set up to install the components at the destination site. Or,
you can specify a rack and Sunair can prepare it for your system.