This RF1350 Mobile set with maximal output power of 50 W can be installed in all wheeled and tracked vehicles. The RF13 transceiver and ZV13.1 amplifier are located on top of each other in a springcushion frame. If the RF1350 Mobile set is designed for installation in wheeled vehicles without artillery or mortar weaponry, or for fixed posts, you may use the lighter, non-cushioned frame 7007.100.01 instead of springcushion frame 7007.100.10. The RF1350 Mobile set can be controlled from one location.
PN (RN): 2011.041.61
| Frequency range | 30.000 MHz to 87.975 MHz |
|---|---|
| Input impedance | 50 Ω |
| Output impedance | 50 Ω |
| Channel spacing | 25 kHz |
| Number of channels | 2320 |
| Channel selection | from transceiver keyboard or handset |
| Operating modes | simplex or semiduplex telephony or data transmission 16 kbit/s |
| Voice encryption | through internal digital scrambler |
| RF power output | 0.2 W reduced, 5 W nominal, 50 W amplified |
| Receiver sensitivity | better than 0.5 μV at 12 dB SINAD |
| Effectively transmitted frequencies range | |
| narrow band | 300 Hz to 3400 Hz |
| wide band | 150 Hz to 9000 Hz |
| Interface for connection of PC | RS232C |
| Data transmission rate in radio channel | max. 16 kbit/s |
| Modulation for data transmission | GMSK |
| Modulation signal level for 4 kHz frequency deviation | for F3 operation 100 mV |
| for data 430 mV ± 50 mV | |
| AF amplifier output power | 1 W in loudspeaker with impedance 6 Ω |
| AF frequency range | 300 Hz to 3000 Hz in 6 dB range |
| Nominal power supply voltage | 27V |
| Power supply voltage range | 18 V to 33 V |
| Current consumption at | |
| reception | 0.5 A/27 V |
| transmission 5 W | 1.3 A/27 V |
| transmission 50 W | 8 A/27 V |
| Continuous operation time in +50 °C | min. 30 minutes |
| Operating temperature range | -30 °C to +60 °C |
| Dimensions including frame (7007.100.20) | W 428 mm x H 224 mm x D 165 mm |
| Set weight including frame (7007.100.20) | max. 15 kg |
| Note: | Customer can order modem in ZV13.1 power amplifier in Net or P2P configuration. |
| RF13 operating instructions | 2000.010.02 |
|---|---|
| RF13 brief operating instructions | 2000.011.02 |
| RF1350 operating instructions | 2011.010.02 |
| RF1350 brief operating instructions | 2011.011.02 |
RF1350 - Mobile set
This mobile set with maximal adjustable output power of 50 W can be installed in all wheeled and tracked vehicles…
RF1350 - Mobile set
This mobile set with maximal adjustable output power of 50 W can be installed in all wheeled and tracked vehicles…